Document LTP0101 rev 2.1f
Available Accessories
Accessories may be purchased through an authorized dealer of AquaCal® products.
- This accessory will override a circulation pump to provide water to the heat pump when the set temperature is not met.
- An Automatic Sequencing Controller (ASC) provides easy control of all units from one lead unit and prevents the simultaneous start-up of multiple heat pumps.
- Site voltage drop is minimized and utilities are not subjected to large in-rush demands of electrical current.
- Part number is based on number of heat pumps to be controlled. Call AquaCal® for assistance with correct configuration. See "Contacting AquaCal AutoPilot, Inc."
- Used for automatic pool / spa thermostat switching.
- This switch can also be used in place of the water pressure switch. This may be needed when the pool / spa elevation is higher than the heat pump. A higher elevation of the water can cause a false signal to the heat pump; indicating water is flowing through the heat pump when it isn't.
- This kit is not to be used on applications exceeding 50 PSI.
- An invisible liquid heat barrier designed to retain heat and extend the swimming season.
- AquaCal® recommends Lo-Chlor® Aqua Blanket™.
- This kit is an additional safety device. It disables the heat pump if any malfunction occurs that allows the water temperature to surpass a safe level.
- This kit is strongly recommended for all spa applications.
- Single Phase Heat Pump - (# STK0221)
- Three Phase Heat Pump - (# STK0222)
Plumbing Unions
- 1 Inch Unions - (# PLP0059)
- 2 Inch Unions - (# PLS2627)
Remote Control Kit (STK0070)
- A remote (wired) control kit allows for full control of the heat pump from up to 100 feet from the equipment.
- This port can be used to adjust water flow using Delta-T.
- The kit comes with port, installation components, and a temperature probe.